How to extend the life of color steel tile forming machine equipment

- Mar 10, 2021-

How to extend the life of color steel tile forming machine equipment


      During the operation of the color steel tile forming machine, some failures often occur, which will not only affect the normal production, but also spend a lot of manpower and material resources to troubleshoot. More importantly, if the color steel tile forming machine often fails, it will have a significant impact on the performance of the color steel tile forming machine in the future. Therefore, the color steel tile forming* manufacturer recommends that you pay attention to its maintenance during use, so as to effectively extend the service life of the color steel tile forming machine. Pay attention to the following points:


      1. Do not operate the equipment higher than the minimum closing height, that is, the minimum distance from the bottom of the upper sliding box to each working surface is 290mm. It is required that the height after the upper and lower molds plus the thickness of the upper and lower substrates plus the thickness of the tile blank shall not exceed 290mm. When manufacturing the mold, it should be designed according to this requirement to avoid machine failure. It is necessary to check the height of the lubricating oil on both sides of the sliding box and the body. The equipment should be cleaned frequently and there should be no dirt or water droplets.

      2. Ensure that the appearance of the color steel tile forming machine is clean. The punching process of the upper die of the color steel tile forming machine is: the input shaft is driven by the motor through the pulley, the upper shaft is driven by the large and small gears, the sliding seat with the upper die is driven upwards, and the cam mechanism slides downwards, so as to achieve the effect of pressing the tiles. .

      3. The rotation position of the worktable is mainly achieved by the gear set installed at the end of the upper shaft, driving the shift pin gear, and moving the sheaves installed on the hexagonal rotating shaft to achieve indexing and positioning. At both ends of the upper shaft, there is a reset cam that is conjugate to the compression cam installed on the same shaft, and the positioning of the lower mold in the working position is realized by the positioning rod and the positioning plate. On the left and right sides of the housing, a lubrication pump is installed. When the machine is working, the oil pipe delivers lubricating oil to the frictional moving parts. If you know the structure, performance and operating regulations of the machine, you can turn on the equipment, otherwise, you can't operate it.

      4. Make sure to check carefully. The height of the sliding box and the lubricating oil on both sides of the machine body and the color steel tile forming machine should be cleaned frequently. There should be no mud or water droplets.