1. Fast forming speed and large output. It adopts PLC programmable controller, automatic control, man-machine interface, and more reliable performance. Easy to operate. Fully hydraulic and pneumatic, the production speed is up to 8 pieces/min, the yield is high, and the cost performance is higher.
2, the mortar concrete is pressure-molded by compression molding, the product structure is perfect, the variety is many, the density is high, the strength is large, the size is accurate, can meet the needs of various buildings, is the fine product of concrete products.
3, a multi-purpose machine. By changing the mold, the machine can produce all kinds of main tiles, ridge tiles, side tiles, drainage tiles, etc. At the same time, it can also produce all kinds of high-grade colored floor tiles, such as terrazzo bricks, polished shot blasting tiles, washed tiles and so on.
The foundation of the cement tile forming machine adopts 200# concrete, and the basic frame of the equipment needs to be buried in the concrete. For details, please refer to the basic layout drawing. Pre-installation inspection: When the equipment is installed, it should be inspected once to check whether the components are damaged due to improper packaging and transportation. Check whether the indirect connection of each component is strong and clean the exposed workpiece. Place the tile machine on the concrete foundation to correct the level.
1. Always pay attention to the occurrence of abnormal conditions during operation, and the fault should be dealt with in time.
2. Always check the lubrication points, fasteners and other parts.
3. Clean the oil filter of the air filter, cooler and fuel tank on time to keep the oil passage clear.
4, the theme part of the theme of color tile equipment should be repaired once every six months, once a year overhaul, so that the automatic tile machine is always in good condition.
5. The hydraulic system of the automatic color tile machine adopts 20# and 30# hydraulic oil. The most suitable oil temperature for hydraulic oil is 30-50 °C. Do not switch on when the oil temperature is lower than 15 °C or higher than 60 °C. In order to adjust the oil temperature, the heating product and the cooler can be used in advance, and the hydraulic oil is added to two-thirds of the liquid level. The hydraulic oil is usually replaced once every 6 months. When replacing, thoroughly clean the fuel tank to remove dirt and dust. The deterioration and brittleness of the hydraulic oil will increase the noise of the system, the life of the oil pump will decrease, and even the entire system will not work. Therefore, it must be paid attention to.